Franklin-fueling-systems T5 Tank Sentinel Programming Guide Bedienungsanleitung PDF herunterladen (Seite 15)

2. Enter an IP address. For simplicity, make the last segment of the IP one number different than the IP address of the

console. Upon initial setup ONLY, the numbers used in the gure may be used to congure the TCP/IP settings of your

PC.

3. Leave the DNS information blank.

Note: The consoles default IP address is 192.168.168.168. If the PC is normally congured to Use the following

IP address, ensure that all display information is recorded and kept prior to making any changes. It may be

necessary to utilize this information to recongure the console once programming is complete.

Check Status of Connection

1. Check the status of your connection by going to the Network Connections window.

2. If the connection status is disabled, enable it by right-clicking on the Local Area Connection and selecting Enable. If

technical difculties arise, please contact Franklin Fueling Systems Technical Support before proceeding.

At this point, more information on navigating TSA is provided in Section 4: TSA of this manual.

Connecting a PC or Laptop to the TS-5 series RS-232 Port

COMM 1 is used to connect a PC or laptop with the console via the TSA interface for programming or remote monitoring.

COMM 2 is not used at this time.

Note: The PC or laptop will recognize this serial connection as a network connection and will not allow the use of a Local

Area Connection simultaneously. While it is not necessary to disconnect the Local Area Connection to connect

using the Serial port, it will be necessary to disconnect the Serial Connection through the computers operating

system in order to use the Local Area Connection again.

Connecting a PC or Laptop to the TS-5 series COMM 1 Port

1. Using a female to male DB-9 straight serial cable, connect the Female end of the serial cable to the serial

communication (COM) port of the computer.

2. Connect the Male end of the serial cable to COMM 1 on the bottom of the console.

Conguring COMM 1 Settings for Communication

1. Select Start > All Programs > Accessories >

Communications > New Connection Wizard.

2. Select Set up an Advanced Connection.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 47 48

Keine Kommentare

Franklin-fueling-systems T5 Tank Sentinel Programming Guide Bedienungsanleitung Seite 15